D-link DI-704 Manual do Utilizador descarregar pdf (Página 11)

Chapter 2 Hardware Installation

2.1. Panel Layout

2.1.1. Front Panel

Figure 2-1 Front Panel

RESET When RESET is pushed, system settings will be set to factory defaults.

M1&M2 System status indicators, Orange. M1 is flashed once per second to

indicate system is alive. When system is busy, M2 is lighted.

WAN & LAN Ethernet port indicators, Green. The LED flickers when LAN or WAN port

is sending or receiving data.

Link/Act. Link status indicators, Green. The LED flickers when the corresponding

port is sending or receiving data

10/100 10/100 status indicators, Green. The LED flickers when the corresponding

port is transmitting or receiving data in 10 or 100Mbps.

Port 1 - 4 LAN port socket (RJ-45). These are where you will connect to device on

your local area network, for example HUB and switch.

2.1.2. Rear Panel

Figure 2-2 Rear Panel

WAN WAN port socket (RJ-45). This is where you will connect to your cable (or

DSL) modem or Ethernet router.

COM Serial port connector (9-pins D-type male). This is where you will connect

your modem. This port is also a console port.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Sem comentários

D-link DI-704 Manual do Utilizador Página 11