D-Link DI-1162M Guia do Utilizador descarregar pdf (Página 83)

DI-1162/DI-1162M Remote Access Router

NAT IP Pool Configuration Screen

Now you must select, enter, and configure the NAT IP Pool from the

NAT Configuration

submenu, shown

below.

Dynamic NAT

This screen (below) is how the NAT IP Pool appears, if

Dynamic NAT

was chosen for the Translation Mode

parameter. Each entry, in this configuration, can be used to map multiple, contiguous global addresses and local

addresses to each other.

The parameters are described below:

♦

Global IP –

An IP Address that is globally unique and valid on the Internet. It is the base, global address for

the global addresses that will be recognized by the interface in the Global Interface parameter.

♦

Range –

This is the range of contiguous, global addresses above (and including) the base Global IP.

♦

Local IP –

An IP Address that is only used in the stub domain since it is not unique. It is the base, local

address for the local addresses that will be recognized by the interface in the Local Interface parameter.

♦

Range –

This is the range of contiguous local addresses above (and including) the base Local IP.

♦

State –

This toggles

Enable

Disable

for this NAT entry.

Dynamic NAPT

This screen (below) is how the NAT IP Pool appears, if

Dynamic NAPT

was chosen for the Translation Mode

parameter. Each entry, in this configuration, can be used to map a single global address and multiple, contiguous

local addresses to each other.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 139 140

Sem comentários

D-Link DI-1162M Guia do Utilizador Página 83