D-Link DXS-3600 Series Guia de Instalação descarregar pdf (Página 14)

DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide

Make sure that there is proper heat dissipation from and adequate ventilation around the switch. Leave at least 10 cm

(4 inches) of space at the front and rear of the switch for ventilation.

Installing the Switch into a Rack

This section is used to guide the user through installing the switch into a switch rack. The switch can be mounted in a

standard 19"(1U) rack using the provided mounting brackets. Use the following diagram as a guide.

Figure 2-2 Fasten mounting brackets on the Switch

How to install the mounting brackets onto the switch (Figure above) and onto the rack (Figure below):

1. Fasten the mounting brackets A and B to the sides of the switch using the screws provided, as seen in the figure

above.

2. Fasten the mounting bracket C in the appropriate open space in the rack using the screws provided, as seen in the

figure below.

3. Simply slide the switch (fastened bracket B into fastened bracket C) into the rack.

4. Lastly, fasten mounting bracket A to the rack using the screws provided.

Figure 2-3 Installing the Switch in a rack

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Sem comentários

D-Link DXS-3600 Series Guia de Instalação Página 14