D-Link DI-1162M Guia do Utilizador descarregar pdf (Página 12)

DI-1162/DI-1162M Remote Access Router

LED STATUS/ FUNCTION

Power Lights whenever the router is plugged in, turned on, and thus

receiving power.

Diag Lights during the startup Power-On Self-Test (POST) test.

Boot Lights briefly during startup after the PROM program has

executed. Indicates a successful boot up.

Run Should be slowly blinking if the router is functioning properly.

10/100 This LED is ON for a 100Mbps link, and OFF for a 10Mbps

link.

LAN

Link/Act This LED is ON to show a good link to the LAN, and quickly

flashes to show communication activity on the line.

Full/Half This LED is ON for a full-duplex connection, and OFF for

half-duplex.

Col The LED flashes to show transmission collisions on the line.

WANs

1 & 2

Ready This LED is ON to show a good modem or CSU/DSU link to

the WAN port.

Act This LED flashes to show communication activity on the line.

Module

Ready This LED is ON to show a good modem or CSU/DSU link to

the WAN module, or a good link to the LAN port module.

Act This LED flashes to show communication activity on the line.

♦

Diagnostics RS-232 Serial Port

A DB-9 female connector used to connect a console to the router for initial

setup and out-of-band management.

♦

Wan Ports (1 and 2)

Two DB-25 male connectors each of which can be connected to a dial-up (dial in or out)

line or a dedicated leased line by multiplexing with a modem or CSU/DSU (Channel Service Unit/ Data

Service Unit), respectively.

♦

Slot for Add-in Module

This slot is able to house any one of the following slide-in expansion modules:

◊

A single RJ-45 10/100 Ethernet port

◊

Two high-speed serial (async/sync) ports

◊

A BRI ISDN module (S/T interface only).

♦

LAN Port

This jack is a full featured RJ-45 10/100 Ethernet/Fast Ethernet port. This feature allows this port

to automatically configure itself to match the settings used by the port it is being connected to. If it is connected

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 139 140

Comentários a estes Manuais

Sem comentários

D-Link DI-1162M Guia do Utilizador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Redes D-Link DI-1162M