D-Link DSA-3200 Informações Técnicas descarregar pdf (Página 93)

xStack

DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide

Last Member Query Interval

(1-25)

This parameter is used to set the maximum amount of time between group-specific

query messages, including messages that have been sent in response to leave

group messages.

Data Driven Group Expiry

Time (1-65535)

Specify the data driven group lifetime in seconds.

Querier State Choose Enabled from the drop-down menu to specify that the Switch should act as

an MLD Querier (sends MLD query packets). Choose Disabled from the drop-down

menu to specify that the Switch should act as a Non-Querier (does not send MLD

query packets).

Fast Done Choose Enabled from the drop-down menu to enable the Fast Done function or

choose Disabled to disable. If it is enabled, the membership is immediately removed

when the system receive the MLD leave message.

State Use the drop-down menu to specify if MLD Snooping should be Enabled or Disabled

from the specified VLAN.

Report Suppression

Use the drop-down menu to enable or disable report suppression function. The

Switch uses MLD report suppression to forward only one MLD report per multicast

router query to multicast devices.

Data Driven Learning State

Use the drop-down menu to enable or disable the data driven learning of a MLD

snooping group.

Data Driven Learning Aged

Out

Use the drop-down menu to enable or disable the aging on the entry.

Version

Use the drop-down menu to specify the version of MLD packets that will be sent by

the specified ports. If an MLD packet received by the interface has a version higher

then the specified version, the packet will be dropped.

After setting the above parameters, click the Apply button in the top section of the window to allow your changes to be

implemented. Click the <<Back button to discard the changes made and return to the previous page.

Click the Modify Router Port link to see the following window:

Figure 3 - 39. MLD Snooping Router Port Settings window

The following parameters can be configured:

Parameter Description

Static Router Port

This section is used to designate a range of ports as being connected to multicast-enabled

routers. This will ensure that all packets with such a router as its destination will reach the

multicast-enabled router regardless of the protocol.

Forbidden Router Port

This section is used to designate a range of ports as being not connected to multicast-

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 320 321

Comentários a estes Manuais

Sem comentários

D-Link DSA-3200 Informações Técnicas Página 93

Comentários a estes Manuais

Manuais e produtos relacionados com Redes D-Link DSA-3200